The 1-Wire temperature sensor is suitable for precise measurement of the outdoor temperature. The water-resistant sensor with stainless steel end cap, can also be used to measure the temperature of liquids or as a contact sensor. The 1-Wire temperature sensor can be connected to any 1-Wire device and is ideal for the following applications:
- precisely measure temperature of liquids
- precisely measure outdoor temperature
- can be attached to a surface and used as a contact sensor
- log temperature while connected to a 1-wire device;
- suited for continuous temperature sensing using Loxone 1-Wire Extension
- suited for use with any 1-Wire device
Technical Data
- Can be supplied with power over the data connection
- Diameter of stainless steel cap is: 6mm
- Accuracy: +/- 0.5°C (at -10…+85°C) / +/- 1°F (at 14…+185°F)
- Measuring Range: -55…125°C / -67…257° F
- Temperature range: -50…105°C / -58…221°F
- Cable withstands a temperature of up to 180°C / 356°F and is made of high quality silicone
New features:
- The serial number of the sensor is shown on the product. There is a label around the sensor with connector description and the serial number!
- Connector description: DQ = white GND = brown VDD = green (also shown on the product itself)
Downloads
Shipped in the Box
- 1 x 2.5m (6.6′) 1-Wire waterproof temperature sensor (DS18B20)
- 1 x Clamp for pipe mounting
If using the Miniserver
Components List
- 1 x Miniserver is required
- 1 x 1-Wire Extension is required
- 1 x Network Switch or Modem required
- 1 x 24VDC Power supply required
Wire List
- 1 x Cat5 or better, network Cable to connect the Miniserver to your network or computer to program the system
- 1 x 18 AWG to 23 AWG pair (solid core preferred) to transfer power from Power supply to Miniserver
- 1 x 18 AWG to 23 AWG pair (solid core preferred) to transfer power from the Power supply or Miniserver to the extension
- 1 x 18 AWG to 23 AWG twisted pair (solid core and shielded preferable) to connect the Miniserver’s Loxone Link to the extension
- 2 x 18AWG to 23AWG twister pair (solid core and shielded preferable) to connect the 1-wire sensors to the 1-Wire Extension
If using the Miniserver Go
Components List
- 1 x Miniserver Go is required
- 1 x 1-Wire Extension is required
- 1 x Network Switch or Modem Required
- 1 x 24VDC Power supply required
Wire List
- 1 x Cat5 or better, network Cable to connect the Miniserver Go to your network or computer to program the system
- 1 x 18AWG to 23 AWG wire (solid core preferred) to ground from Power supply negative to the Miniserver Go
- 1 x 18 AWG to 23 AWG pair (solid core preferred) to transfer power from Power supply to extension
- 1 x 18 AWG to 23 AWG pair (solid core and shielded preferable) to transfer power from the Power supply to extension
- 1 x 18 AWG to 23 AWG twisted pair (solid core and shielded preferable) to connect the Miniserver Go’s Loxone Link to the extension
- 2 x 18AWG to 23AWG twister pair (solid core and shielded preferable) to connect the 1-wire sensors to the 1-Wire Extension